1172
Kommentar:
|
1432
|
Gelöschter Text ist auf diese Art markiert. | Hinzugefügter Text ist auf diese Art markiert. |
Zeile 41: | Zeile 41: |
a Versaloon adapter instead of the original ST-Link software. | a Versaloon adapter instead of the original ST-Link software. I took the following descriptions: * http://hackaday.soup.io/post/106677690/Versaloon-ported-to-STM8-and-STM32-discovery * http://takenapart.com/?p=82 These two fotos show my connections between the two board: |
Zeile 46: | Zeile 52: |
My configuration file is ``vsllink_swd.cfg``: | My configuration file is vsllink_swd.cfg``: |
Zeile 57: | Zeile 63: |
Here I have the same problem. | On OpenOCD startup I have the same problem as written above: |
Zeile 59: | Zeile 65: |
:: | {{{ |
Zeile 62: | Zeile 68: |
}}} |
OpenOCD
Serial Wire Debug (SWD)
2011-02-23
Recently I tried to test the SWD debug transport over a FT2232 based JTAG adaptor and over a Versaloon (based on STM32) adaptor. The debug target was a STM32 Discovery board.
FT2232 Adaptor
I modified the adaptor configuration file, so that SWD is enabled. Is this correct?
interface_transports swd interface ft2232 transport select swd ft2232_vid_pid 0x0403 0x6010 ft2232_device_desc "Dual RS232" ft2232_layout "oocdlink" ft2232_latency 2 jtag_khz 200
OpenOCD does not start. It complains with an error message:
::
- Error: BUG: current_target out of bounds
Versaloon
I have two *STM32 Discovery* Boards and modified one of them to have a Versaloon adapter instead of the original ST-Link software. I took the following descriptions:
These two fotos show my connections between the two board:
My configuration file is vsllink_swd.cfg:
interface_transports swd interface vsllink # transport select swd swd_mode 2 swd_delay 2
On OpenOCD startup I have the same problem as written above:
Error: BUG: current_target out of bounds